Coala Canvas S

Printing

• Ink coverage of up to 250% is recommended.
• Suggested heater settings: pre-heat 58° C, print heat 52° C.
• Due to the heavy weight of the canvas, feed rate through the
printers may not be consistent, causing prints to differ slightly in
size from print to print or from the expected size after Ripping.
• To optimize print quality, printers should be set for highest print quality

Forming

• After printing, material should be permanently attached to a
rigid board or frame with staples or tacks.
• Using glue or pressure sensitive adhesives is not recommended,
as this does not prevent the material from natural environmental
shrinkage over time.
• When the material shrinks, the adhesive may fail, causing edges
to curl and possible delamination. Shrinkage may also cause
spacing between paneled job not mounted properly. All edges
of the material should be affixed to the mounting surface to
prevent the edges from curling. All canvas is susceptible to edge
cracking if stretched improperly.

Pack and
size options

Environmental
credentials

Suitable for