Kernowjet Metalik

Printing

As with all filmic media, this product must be allowed to “gas-out” after printing. This can be achieved by leaving the prints face up,
ideally 24+ hours, to set, dry and harden. If unable to do this e.g. with a long print run: after printing the roll stand it vertically and
loosely unwind the printed roll as much as possible, to allow air in and gases/solvents out.

Finishing

High Gloss Metallic

Storage Recommendations

10°C - 20°C / 20% - 50% RH

Pack and
size options

Environmental
credentials

Suitable for

Applications and
guarantees