Printing
Universal Liner construction, correctly printed, eliminates the “bridging” over the perforated holes that can occur with UV curing inkjet printers and Replacement Liner construction.
After printing the ink must be thoroughly dry, including in the perforated holes to avoid any contamination, particularly during lamination.
Finishing
Apply the film using a dry application method. Surfaces to which the material will be applied must be thoroughly cleaned from dust, grease or any contamination. Final clean with soap and water. Rinse and dry glass after cleaning.
Not to be applied to fresh paint or ink, polycarbonate, rubber, plastic moldings and certain PVCs. In case of doubt, please test prior to final application.
This product is not recommended for use around a sharp angle where there is a limited area either side of the angle.
The film must not touch the rubber window molding. If two graphic panels meet side by side on a window, carefully trim the
film so that the panels meet and form a butt seam. Do not overlap the panels.
Observe the minimum application temperature, and the graphics should not be washed within 24 hours of application.